LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (40 - Wheel Suspension Front Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 400619 Removing And Installing Front-Axle Carrier >> Subsequent Work >> Subsequent Work For Removing And Installing Front-Axle Carrier

Subsequent Work For Removing And Installing Front-Axle Carrier

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. On vehicles with 19-inch brake system:

    Fit the air guide.

    > 407719 REMOVING AND INSTALLING FRONT ANTI-ROLL BAR (PDCC)  - section on "Installing"

  2. Fit engine guard.

    > 108019 Removing and installing engine guard - section on "INSTALLING "

  3. Fit the front wheels.

    > 440519 Removing and installing wheel - section on "INSTALLING "

  4. Remove engine support at the body.

    > 1001IN SUPPORTING THE ENGINE ON THE BODY

  5. Bleed the power steering.

    > 4890IN TEST AND ASSEMBLY WORK ON POWER STEERING

  6. Bleed the PDCC system.

    > 430307 BLEEDING PORSCHE DYNAMIC CHASSIS CONTROL (PDCC)

  7. Perform suspension alignment.

    > 449503 SUSPENSION ALIGNMENT, COMPLETE

scientia non olet · About LEMON Manuals