Installing Front Level Sensor
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- In running gear with level adjustment, a level sensor is installed on each spring strut.
- The level sensor is screwed to the body and upper control arm.
- Position level sensor -1-
and holder -4-
and screw in the fastening screw -3-
.
> 4X00IN TIGHTENING TORQUES FOR LEVELLING SYSTEM/PORSCHE DYNAMIC CHASSIS CONTROL (PDCC)
Make sure that the level sensor linkage is facing outwards. > Installing front sensor for levelling system
- Plug in electric plug connection -2-
on the level sensor -1-
(-A-
) and lock it -a-
.
Installing front sensor for levelling system
- Press linkage holder -1-
into the upper trailing arm -2-
(-A-
).
Make sure that the holder -1- is seated correctly in the upper trailing arm -2- (-B- ).
Installing holder
- Press locking pin -3- as far as it will go into the holder -1- (-C- ).