LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (37 - Automatic Transmission - Actuator, Housing (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 374055 Replacing Transmission Mount >> Installing Transmission Mount

Installing Transmission Mount

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert new transmission mount into calibrating sleeve T10214/2  and fit tool T10214/3  on the plastic ring of the mount without screwing it to the mount.
    G16317630Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Inserting transmission mount in tool

  2. Fit calibrating sleeve T102I4/2 -2-  on tool T10214/1 -1-  . Press transmission mount into the calibrating sleeve T10214/2 -2-  until it is flush with the upper edge -arrows-  .
    G16317631Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Calibrating transmission mount

  3. Screw the tool T10214/3  to the calibrated mount.
    G16317632Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Screwing on tool

  4. Position tool T10214/2/3  together with the new mount on the transmission support. Make sure that the notch on the special tool is aligned with the marking applied to the transmission support before removal -arrows-  .
    G16317633Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Aligning transmission mount

  5. Position tool T10214/1 -1-  under the opening in the transmission support and press transmission mount -2-  into the transmission support using the workshop press. Make sure that the mount is aligned with the transmission support -arrows-  .
    G16317634Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pressing in transmission mount

  6. The mount is at the correct installation position when the tool T10214/2  can move freely.
    G16317635Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Tool moving freely

  7. Unscrew tool T10214/3  from the transmission mount.
    G16317636Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unscrewing tool

  8. Fit tool T10214/3  on the projecting side again and press the transmission mount in flush again until it is installed evenly in the transmission support.
scientia non olet · About LEMON Manuals