Installing Selector Lever Cable

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Check that the rubber sleeve for the selector lever cable is seated correctly to prevent noises and stop water from leaking in. Spray the rubber sleeve with soapy water to make fitting easier.

Insert rubber sleeve -2- for the selector lever cable -1- into the centre tunnel -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting rubber sleeve
Install selector support.
> 370819 Removing and installing selector support - section on "INSTALLING "
Insert tab washer -1- (-A- ).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Securing selector lever cable on transmission
Press the selector lever cable -2- onto the ball joint -B- .
Shift the transmission to position N -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Shifting transmission to position N