Installing Exhaust System

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

For tightening torques, tightening sequence and assembly overviews for the engine and transmission:

Push new exhaust clamps (clamping sleeves) -3- onto the exhaust pipes. The threaded joint must be pointing downwards.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting clamps
Get another person to help secure the exhaust system.
Position the exhaust system under the vehicle. Do not install too tightly.
Tighten four fastening screws for the brackets on the rear silencer.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Securing bracket on rear silencer
Tighten fastening screw on the centre bracket.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening centre bracket

The threaded joint on the exhaust clamps must be pointing downwards. Adjust to maximum inclination -3- and ensure the assembly length is the same on both exhaust pipes -Arrows- .

Maximum inclination -3- :

> Adjustment value 10°

Gap between the exhaust pipes -1- :

> Adjustment value 5 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of exhaust clamp

1	Gap between the exhaust pipes
2	Length of exhaust clamp
3	Maximum inclination