LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (20 - Fuel Supply, Actuator (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 206619 Removing And Installing Fuel Pump >> Installing Fuel Pump

Installing Fuel Pump

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the pump in the holder on the tank floor and turn it approx. 90° to the right until it is seated securely.
    G16310178Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Turning the pump

  2. Connect the sucking jet pump connections -1 and 2-  at the fuel pump. These must lock with an audible click.
    G16310179Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Connecting sucking jet pump connections

  3. Connect the connection -3-  until it engages securely.
  4. Fit a new seal in the opening of the tank at the left and right. > Seal 
    G16310180Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Seal

  5. Pull the fuel line on the pressure regulator through the fuel tank to the left connection unit using the attached piece of wire or similar item.
  6. Clip in the fuel line -3-  on the left connection unit.
    G16310181Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fuel line on left connection unit

  7. Connect all connections on the underside of the right connection unit.
  8. Insert the left and right connection unit into the tank. When doing so, make sure that the plastic lugs are pointing forward.
scientia non olet · About LEMON Manuals