Installing Fuel Supply Line
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The description applies to all engine types.
- The setup and procedures required may differ slightly from the illustrations or procedures described due to engine-specific differences.
- The fuel supply line is installed in reverse order to removal.
- Tighten fastening screws on restraining straps to > Tightening torque 23 (17 ftlb.) Nm .
- Tighten three M6 collar nuts to > Tightening torque 10 (7.5 ftlb.) Nm and one M6 fastening screw to > Tightening torque 10 (7.5 ftlb.) Nm .
- Tighten two fastening screws for the heat shield on the cardan shaft to > Tightening torque 10 (7.5 ftlb.) Nm and one collar nut for the heat shield on the cardan shaft to > Tightening torque 20 (15 ftlb.) Nm .