Component Overview

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cylinder-Head Cover Gaskets Components Location - Cylinders 1 To 4

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cylinder-head cover gaskets, cylinders 1 to 4

1	Cylinder head cover for cylinders 1 to 4 (align over bar ignition modules)
2	Oil cap
3	Aluminium screw , M6 x 20; hall sender (phase sensor); always use new aluminium screws
4	Hall sender
5	Sealing ring/replace
6	Cylinder-head cover gasket/replace
7	Cylinder-head cover gasket, inner/replace
8	Seal on hydraulic valve for camshaft control/replace

Fig 2: Cylinder-Head Cover Gaskets Components Location - Cylinders 5 To 8

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cylinder-head cover gaskets, cylinders 5 to 8

1	Cylinder head cover for cylinders 5 to 8 (align over bar ignition modules)
2	Hall sender
3	Aluminium screw , M6 x 20; hall sender (phase sensor); always use new aluminium screws
4	Sealing ring/replace
5	Cylinder-head cover gasket/replace
6	Cylinder-head cover gasket, inner/replace
7	Seal on hydraulic valve for camshaft control/replace

Fig 3: Bar Ignition Modules And Cylinder Head Cover Components Location - Cylinders 1 To 4

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bar ignition modules and cylinder head cover for cylinders 1 to 4

1	Cylinder head cover for cylinder bank 1 to 4 (align over bar ignition modules)
2	Bar ignition module
3	Aluminium screw , M6 x 20; bar ignition module; always use new aluminium screws
4	Aluminium screw , M6 x 30; always use new aluminium screws
5	Cap
6	Steel screw on eyelet
7	Eyelet
8	Aluminium screw , M8 x 35 (on torque support); always use new aluminium screws; steel screw on eyelet!

Fig 4: Bar Ignition Modules And Cylinder Head Cover Components Location - Cylinders Bank 5 To 8

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bar ignition modules and cylinder head cover for cylinder bank 5 to 8

1	Cylinder head cover for cylinder bank 5 to 8 (align over bar ignition modules)
2	Eyelet
3	Steel screw on eyelet
4	Aluminium screw , M6 x 30; always use new aluminium screws
5	Bar ignition module
6	Aluminium screw , M6 x 20; bar ignition module; always use new aluminium screws
7	Sheetmetal holder
8	Cap