Subsequent Work
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Install oil pressure indicator sensor with adapter.
- Install the chain tensioner.
- Install alternator.
- Install turbocharger suction and pressure hose on cylinder bank 1.
- Install new joint flange with crankshaft sealing ring.
> WM, 137419 REMOVING AND INSTALLING SEALING RING FOR CRANKSHAFT PULLEY
- > 9861 - Dismantle the timing tool on the camshafts of both cylinder banks.
- Fit and secure belt pulley with friction washer.
> WM, 137619 REMOVING AND INSTALLING VIBRATION DAMPER (CRANKSHAFT PULLEY)
- Check the timing.
TDC position of camshafts
- 8.1 Turn the engine two turns clockwise to TDC of cylinder 1 and lock the belt pulley using > 9595/1 - locating pins.
- 8.2 Check camshaft adjustment.
- 8.2.1 If the control chain is still in the same position as it was during removal, remove > 9595/1 - locating pins and continue with Step 7.
- 8.2.2 Only set the timing if the control chain has skipped.
- Install both cylinder head covers.
- Install coolant pump belt pulley.
- Install the drive belt.
- Fasten the coolant pump belt pulley.
- Install the hat for the throttle body complete with both moulded hoses.
> WM, 243519 REMOVING AND INSTALLING COWL FOR THROTTLE HOUSING (Y-PIPE)
- Assemble the lock support panel and bumper complete with all radiators.
Radiator assembly with lock support panel and bumper - Similar to illustration
- 14.1 Attach the complete cooler package with a helper.
- 14.2 Tighten screw securing -1-
ATF lines -3-
to thermostat -4-
.
ATF lines on the thermostat
- 14.3 Fasten the refrigerant line screws to the condenser.
Use new O-rings.
Screws air conditioning lines on the condenser
For details, see:
- 14.4 Secure hydraulic lines to the power-steering radiator in the left longitudinal member area.
Hydraulic lines for power steering
- 14.4.1 Push on -2- hoses and fasten clamps -1- .
- 14.5 Secure electric plug connections.
- 14.5.1 Secure the electric plug connection -6- of the cable harness on the left-hand side.
Electric plug connection left
- 14.6 Secure electric plug connection -8-
on the right side.
Electric plug connection right
- 14.7 Secure decoupler for flap cable to the upper left longitudinal member.
For details, see:
Removing cable from mounting
- 14.8 Tighten screws -5-
for the longitudinal member.
Detaching bumper
For details, see:
- 14.9 Tighten screws -4-
for the bumper.
Loosening lock support panel
For details, see:
- Install the front bumper.
- Install both air cleaner housings.
- Add refrigerant.
- Refill coolant.
> WM, 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING)
- Filling engine oil.
- Fill in hydraulic fluid.
- Connect the battery.