Preliminary Work: Notes
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Check that the following assembly preconditions have been met:
- Oil guide housing pre-fitted with oil filter and oil/water heat exchanger.
- Check that the oil mist separator is pre-fitted with seals and screw elements.
- Check cylinder head cover (valve cover) to ensure that surrounding seal, seals for spark plug recesses, seal for hydraulic valve of camshaft control, hall sender for camshaft and oil filler cover are fitted.
- Intake-air distributor with seals, heat socket, screws and throttle housing inserted.
- Generator with both fitted coolant connection pieces and sheetmetal cable holders.
- Upper part of crankcase fitted on flywheel side with two water plugs. Screw plugs fitted.
- The upper part of the crankcase is located together with the engine support > 9676/1 - engine support attached to the assembly support. Use the four screws > 9590 - mounting parts and tighten them.
> 1001IN SECURING ENGINE ON ASSEMBLY SUPPORT (MOUNTING BRACKET) ]