LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (10 - Engine - Crankcase, Suspension (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 100119 Removing And Installing Engine >> Subsequent Work >> Subsequent Work For Removing And Installing Engine

Subsequent Work For Removing And Installing Engine

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. On vehicles with 19-inch brake system: Fit the air guide at the anti-roll bar.

    > 407719 Removing and installing anti-roll bar -  "INSTALLING "

  2. Fit front wheel housing liners.

    > WM 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER "Installing"

  3. Fit wheels.

    > 440519 Removing and installing wheel -  "INSTALLING "

  4. Install right cross panel.

    > WM 508119 REMOVING AND INSTALLING CROSS PANEL "Installing"

  5. Fit torque support.

    > 103719 Removing and installing torque support -  "INSTALLING "

  6. Fit design cover on the throttle valve.

    >WM, 108319 REMOVING AND INSTALLING ENGINE COVER (DESIGN COVER)  "Installing"

  7. Connect the battery.

    > 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY

  8. Fill the air conditioning system.

    >WM 870317 ADDING REFRIGERANT AND REMOVING BY SUCTION (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0)) .

  9. Check engine-oil level.

    > 170117 CHANGING ENGINE OIL AND OIL FILTER

  10. Bleed the cooling system.

    > 193817 Draining and filling coolant (includes bleeding) -  "FILLING "

  11. Bleed the power steering.

    > 4890IN TEST AND ASSEMBLY WORK ON POWER STEERING

  12. Bleed the PDCC system if necessary.

    >WM, 430307 BLEEDING PORSCHE DYNAMIC CHASSIS CONTROL (PDCC)

  13. Check ATF level and top up if necessary.

    > 370235 CHECKING AND TOPPING UP ATF

  14. Move bonnet out of service position.
  15. Fit engine compartment trim panels.

    > WM 700219 REMOVING AND INSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0)) "Installing"

  16. Perform suspension alignment.

    > 449503 SUSPENSION ALIGNMENT, COMPLETE

  17. The high-pressure adaptation must be reset when replacing the engine.
  18. Read out DME fault memory and compare with the log you printed prior to removal.
scientia non olet · About LEMON Manuals