Subsequent Work

Replace seals when refitting the flanges. > Seals on flanges

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seals on flanges
Close the tank. To do this, fit the sheetmetal ring on the left and right connection unit and tighten using > T10202 - key. > Cap > Tightening torque 145 (107 ftlb.) Nm +/- 5 (3.5 ftlb.) Nm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cap
Fit all connections of the right connection unit (fuel lines, ventilation tubes and electric connectors).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fuel supply and connection points at right connection unit
Plug in electric plug connection for the left connection unit.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Left connection unit connector
Fit left and right lid. Then tighten the four fastening nuts. > Fastening nuts on caps > Tightening torque 10 (7.5 ftlb.) Nm Refit the carpeted floor and fix with double-sided adhesive tape.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening nuts on caps
Install rear seat.
> Refer to the appropriate service information - section on "Installing"