LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Cayenne S >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 10 - Engine - Crankcase, Suspension -- 92AA1 Cayenne 3.6L >> WM, 100119 Removing And Installing Engine >> Subsequent Work

Subsequent Work

  1. On vehicles with manual transmission, work on peripheral units must be performed as described in

    > WM 343519 REMOVING AND INSTALLING TRANSMISSION (CAYENNE TIP)

  2. Install intake pipe.

    > WM, 243519 REMOVING AND INSTALLING AIR BOX FOR THROTTLE HOUSING (INTAKE PIPES UPSTREAM OF THROTTLE VALVE)

  3. Install cover for plenum panel.

    > WM 664419 REMOVING AND INSTALLING COWL PANEL COVER (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))

  4. Fit pneumatic springs for bonnet

    > WM 553119 REMOVING AND INSTALLING FRONT PNEUMATIC SPRING (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))

    Fit rubber seal for engine compartment at the same time.

  5. Fill and bleed the cooling system.

    > WM, 193817 DRAINING AND FILLING COOLANT

  6. Connect the battery.

    > 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY

  7. Fit engine compartment trim panels.

    > WM 700219 REMOVING AND INSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))

  8. Check ATF level.
  9. Bleed the power steering or PDCC.
  10. Install front wheel housing liners.

    > WM 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER

  11. Install engine guard with transverse strut.
  12. Mount front wheels.

    > WM 440519 REMOVING AND INSTALLING WHEEL (EXCEPT CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S HYBRID, CAYENNE S E, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))

  13. Perform suspension alignment.
  14. Perform a test drive with the vehicle. Check the fluid level in the reservoir after the coolant circuit has cooled again and, if necessary, fill up to the max marking with coolant.
  15. Read out DME fault memory and compare with the log you printed prior to removal.
  16. Check fluid levels.
scientia non olet · About LEMON Manuals