Installing Exhaust System

Information 

Tightening Torques, tightening sequence and assembly overviews for the engine and transmission:

• Group 1: →  1X00IN TECHNICAL VALUES 
• Group 2: →  2X00IN TECHNICAL VALUES 
• Group 3: →  3X00IN TECHNICAL VALUES 

1. Push new exhaust clamps (clamping sleeves) -3-  onto the exhaust pipes. The threaded joint must be pointing downwards.
   Fig 1: Fitting Clamps

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Get another person to help secure the exhaust system.
3. Position the exhaust system under the vehicle. Do not install too tightly.
4. Tighten four fastening screws for the brackets on the rear silencer.
   Fig 2: Securing Bracket On Rear Silencer

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Tighten fastening screw on the center bracket.
   Fig 3: Tightening Centre Bracket

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. The threaded joint on the exhaust clamps must be pointing downwards. Adjust to maximum inclination and ensure the assembly length is the same on both exhaust pipes. → see Fig 4→ Adjustment value: 10° 
   Fig 4: Identifying Exhaust Clamp Installation Position

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. Gap of approx. 5 mm between the exhaust pipes
   2. Length of exhaust clamp
   3. Maximum inclination