LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> 42 Rear Wheel Suspension Drive Shaft 2.0L -- 982 - BOXSTER/CAYMAN >> WM, 421119 Removing And Installing Lower Trailing Arm >> Removing And Installing Lower Trailing Arm >> Removing Lower Trailing Arm

Removing Lower Trailing Arm

  1. Disconnect angle sensor at the lower holder.
    1. 1.1  Counter the ball joint screw -2-  using an open-ended wrench and use a second open-ended wrench to unscrew the fastening nut -1-. Pull the connecting link -3-  down -a-  .
      G14946987Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Loosening connecting link

  2. Remove threaded joint -4-  from the diagonal control arm.
  3. Screw off lock nut -1-  Counter with a Torx screwdriver at the ball-joint pin while doing this.
  4. Press lower trailing arm -2-  off the wheel bearing housing using > 9560 - press-off tool-6-. 
  5. Mark the position of the camber eccentric adjuster -3-  on the rear-axle carrier side section.
  6. Remove camber eccentric adjuster -3-  and remove lower trailing arm.
    G14946988Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Loosening rear trailing arm

scientia non olet · About LEMON Manuals