LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> 42 Rear Wheel Suspension Drive Shaft 2.0L -- 982 - BOXSTER/CAYMAN >> WM, 420619 Removing And Installing Rear-Axle Cross Member >> Removing And Installing Rear-Axle Cross Member >> Installing Rear-Axle Cross Member

Installing Rear-Axle Cross Member

  1. Fit rear-axle cross member -2-  and tighten fastening screw -1-  on both sides of the vehicle (tighten fastening screw using a joint and extension and counter at the fastening nut with a ring wrench). > Tightening torque 65 Nm (47.9 ftlb.) 
    G14946977Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for rear-axle cross member

    Information 

    When fitting the angle sensor, always make sure that the holder on the rear-axle cross member is aligned correctly. > Alignment of angle sensor holder 

    G14946978Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Alignment of angle sensor holder

  2. Fit angle sensor -1-  (with holder) on the rear-axle cross member on both sides of the vehicle.
    G14946979Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Angle sensor mounting

    1. 2.1  Tighten fastening screw -2-  using > V.A.G 1331/13 - Ring wrench insert, a/f 10  . > Tightening torque 10 Nm [7.5 ftlb.) 
scientia non olet · About LEMON Manuals