Subsequent Work

NOTIFICATION 

Risk of damage to cover if excessive heat is applied. 

• Creases in cover 

If creases have formed, only short partial warming with the hot-air gun is permissible.

→ The hot-air temperature of 50°C must always be observed.

1. If creases have formed, partially heat the affected areas of the cover with a hot-air blower > V.A.G 1416 - Hot-air blower and smooth out the cover using the following special tools:

   > 9747 - Wetting-off iron 

   > 9747/1 - Knurling tool 

   > 9747/2 - Bone burnisher 

2. Install control button for backrest adjustment at the left and right.

   > 723155 REPLACING CONTROL BUTTON FOR BACKREST ADJUSTMENT

3. Install backrest cover.

   > 722655 REPLACING BACKREST COVER

4. Install cover for front middle backrest.

   742019 REMOVING AND INSTALLING COVER FOR FRONT MIDDLE BACKREST 

   > 742019 REMOVING AND INSTALLING COVER FOR FRONT MIDDLE BACKREST (AIR-CONDITIONED COMFORT SEAT) 

5. Install front seat.

> 720119 REMOVE AND INSTALL FRONT SEAT