LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera Turbo >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> 85 - Ventilation -- PANAMERA (970) >> WM 852219 Removing And Installing Plenum Panel Cover (Except PANAMERA S Executive, PANAMERA Executive, PANAMERA 4 S Executive, PANAMERA Turbo Executive, PANAMERA GTS, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Removing Plenum Panel Cover

Removing Plenum Panel Cover

  1. Loosen the rear lid seal -1-  .
    1. 1.1. Lift up the foam corner piece -3-  .
      Fig 1: Pulling Off Profile Seal On Lid At Front
      G09813240Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    2. 1.2. Pull seal off as far as required until the plenum panel cover is free.
  2. Detach front profile seal on the lid -2-  .
    1. 2.1. Pull the end -1-  of the front profile seal off the retaining lug -2-  against the direction of travel.
      Fig 2: Unhooking Profile Seal
      G09813241Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    2. 2.2. Lift up the seal and pull it off as far as required until the plenum panel cover is free.
  3. Unscrew and remove the three fastening screws -1-  .
    Fig 3: Removing Fastening Screws
    G09813242Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Remove plenum panel cover.
scientia non olet · About LEMON Manuals