Removing Throttle Housing

Fig 1: Intake Module On Naturally Aspirated Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake module on naturally aspirated engine

1	Intake module
2	Decoupling module (fastening part); observe specified tightening sequence
3	Screw, 5 x 16
4	Pressure sensor
5	Intake module seal; check that seal is aligned and fitted correctly!
6	Heat socket
7	Screw, 6 x 50
8	Electronic accelerator/throttle housing
9	Seal
10	Lan socket

Fig 2: Intake Air Module On Turbo Engine Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake air module on turbo engine

1	Intake module
2	Decoupling module (fastening part); observe specified tightening sequence
3	Screw, 5 x 16
4	Pressure sensor
5	Intake module seal; check that seal is aligned and fitted correctly!
6	Heat socket
7	Screw, 6 x 50
8	Electronic accelerator/throttle housing
9	Seal
10	Ball socket

Disconnect cable plug on the throttle housing and pull cable out of the clip.
Loosen the four screws on the throttle housing -arrows- . Remove throttle housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Throttle adjuster
Check the condition of the sealing ring. Replace sealing ring if necessary >.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sealing ring for throttle housing