Fitting Parts On The New Transmission

Fit speed sender -1- at the clutch bell-housing. → Tightening torque: 10 Nm (7.5 ftlb.)

Fig 1: Identifying Speed Sender At Clutch Bell-Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide breather hose onto the bleeder.

Fig 2: Identifying Breather Hose
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit gearshift lever -1 and 3- on the transmission. To do this, screw in fastening nuts -2- . → Tightening torque: 23 Nm (17 ftlb.)

Fig 3: Fitting Gearshift Lever On Transmission
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit support for operating cables. To do this, screw in fastening screws -1- . → Tightening torque: 23 Nm (17 ftlb.)

Fig 4: Fitting Support For Operating Cables
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit plastic cap on the transmission bell housing.

Fig 5: Locating Plastic Cap On Transmission Bell Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.