Installing Generator
- The generator is installed in reverse order to removal.
- Fit the retaining bracket:
- 1.1. Fit the generator.
- 1.2. Fit retaining bracket and secure with the fastening screw.
- 1.3. The generator is screwed to the engine.
- 1.4. Insert B+ line into the retaining clip and screw it to the generator.
- 1.5. Only now should you lift the retaining bracket against its stop and tighten the fastening screw.
- The specified tightening torques must always be observed → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS
.
- The generator is installed in reverse order to removal.
- Fit the retaining bracket:
- 1.1. Fit the generator.
- 1.2. Fit retaining bracket and secure with the fastening screw.
- 1.3. The generator is screwed to the engine.
- 1.4. Insert B+ line into the retaining clip and screw it to the generator.
- 1.5. Only now should you lift the retaining bracket against its stop and tighten the fastening screw.
- The specified tightening torques must always be observed → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS
.