Installing Front-Axle Valve Block
- The front-axle valve block is installed in reverse order to removal.
Valve block to:
Oil pressure lines to valve block: Tightening torque 28 Nm (21 ftlb.)
Transverse strut to inner body:
Transverse strut to outer body (door sill):
NOTE: Incorrect line routing- Risk of damage to lines and hoses
- Malfunction and fault memory entry on control unit
→ Avoid small bending radii when routing lines.
→ File down edges and burrs in the routing area or mask them with adhesive tape.
→ Maintain a sufficient distance from components exposed to high temperatures while driving.
- When re-installing the steel flexi-pipes, observe the markings you applied earlier to prevent the pipes from becoming twisted.