Installing Solenoid/Hydraulic Valve For Camshaft Controller

Information 

The tightening specifications for the basic engine are stored centrally.

> Refer to 1X001N Technical values in the appropriate service information. 

> Refer to 2X001N Technical values in the appropriate service information. 

or

> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

1. Replace sealing ring on hydraulic valve. Do not insert sealing ring twisted when fitting it.
2. Coat sealing ring lightly with engine oil and insert hydraulic valve into the cylinder head. Any installation position is possible
3. Fit and tighten fastening screws.
   Fig 1: Camshaft Control Components Location

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Camshaft control

   1	Screw, M12 Tighten fully after setting valve timing. Always use a new screw
   2	Camshaft controller with Integrated hexagon for countering
   3	Hydraulic valve for camshaft control
   4	Screw, M5 x 12