Preparing Center Side Member For Installation

Make slots for MIG seams.
1. 1.1. Mark positions of slots for MIG seams.
  → Distance: 25 mm → Distance: 80 mm → Width: 10 mm → Length: 45 mm → Distance: 60 mm → Width: 10 mm → Length: 25 mm → Distance: 60 mm → Distance: 25 mm → Width: 10 mm → Length: 45 mm
2. 1.2. Make slots for MIG seams.
  
  Fig 1: Identifying Positions Of Slots For MIG Seams On Center Side Member (1 Of 3
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 2: Identifying Positions Of Slots For MIG Seams On Center Side Member (2 Of 3)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 3: Identifying Positions Of Slots For MIG Seams On Center Side Member (3 Of 3)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Prepare connection areas for bonding.

Fig 4: Identifying Bonding Areas On Center Side Member For Installation
Courtesy of PORSCHE CARS NORTH AMERICA, INC.