Installing Gearshift Bracket
- Insert operating cables into gearshift bracket and install safety clips -arrows-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Insert cable ends -arrow-
into the adjuster.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Align gearshift bracket in neutral position using locking bridge 9619/2
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- When fitting the gearshift bracket, adjust the position -X-
of the operating cables before removal and latch in adjuster.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Screw in fastening screws -arrows-
for cover on gearshift bracket.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Locking bridge 9619/2
on the gearshift bracket must be removed.
- Install gearshift bracket together with operating cables.
- Guide rubber sleeve on the operating cable through the support and latch the cable ends -1-
onto the transmission.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Insert safety clips -2-
on the support.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Check position of clips using a mirror.
- Press gearshift bracket into the cut-out in the cardan tunnel.
- Screw in fastening screws for transmission support. → Tightening torque: 65 Nm (48 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Tighten fastening screws -arrows-
for gearshift bracket to cardan tunnel. → Tightening torque: 6 Nm (4.5 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Release adjuster -arrows-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Align gearshift bracket in neutral position using locking bridge 9619/2
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Latch adjuster -arrows-
into place
Courtesy of PORSCHE CARS NORTH AMERICA, INC.