LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera Edition >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (27 - Starter, Power Supply, Cruise Control 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 278515 Adjusting Control Unit For Distance Measuring Sensor >> Preliminary Work >> Test Prerequisites

Test Prerequisites

WARNING: This page is about a different variant/trim than selected.
  1. The tread depth on one axle must not differ by more than 2 mm.
  2. Tyre pressure of tires in accordance with regulations (regardless of "Comfort" or "Normal" air pressure).
  3. As with complete suspension alignment, make sure that there is no sliding base or template at the end stop during alignment.

    Take the toe width and wheel base into consideration.

  4. Check that vehicle weight corresponds to empty weight. Weight of the vehicle ready for driving (completely full fuel tank and water tank for the windscreen washer/headlight cleaning system, spare wheel, tool kit, jack) without driver.
  5. Spare wheel, tool kit, jack must be located in the positions specified by the vehicle manufacturer.
  6. Vehicle aligned correctly, having been bounced and allowed to settle multiple times.
  7. Check wheel suspension, steering and steering linkage for play and damage.

    Carry out repairs if necessary.

  8. Adjust vehicles with levelling system (air spring) to normal level*.

    *Information: Engine/ignition off, doors closed, lock the vehicle

    Wait for 15 seconds (air spring corrects vehicle)

    Unlock vehicle, open door and leave open during the measurement, switch on ignition

scientia non olet · About LEMON Manuals