Subsequent Work
WARNING: This page is about a different variant/trim than selected.
Additional scope for turbo engines:
- Install pressure and suction hoses close to cylinder 1-4
> 214119 REMOVING AND INSTALLING PRESSURE PIPE
Install intake pipe on the right (in direction of travel) at the bottom in front of the turbocharger.
Install lower pressure pipe at the right (in direction of travel) between the charge-air cooler and turbocharger.
Install pressure pipes at the top in front of the throttle valves.
All vehicles:
- Install drive belt deflection roller.
- Install drive belt
- Install air-cleaner cowl
- Fill in coolant
- Install cooling fan housing
> Refer to 192019 Removing and installing cooling fan housing (radiator frame) in the appropriate service information. - section on "Installing"
On vehicles with PDCC , clip in the lines on the front-axle carrier.
- Install cover for front underbody.
- Install front wheel housing liner at the right.
- Install front right wheel
- Connect the battery