Removing Engine From Engine Carrier (Removing Engine)
- Also support engine on the assembly table at the front.
- For all-wheel drive vehicles: Loosen front drive shafts on the transmission side → 404119 REMOVING AND REINSTALLING FRONT DRIVE SHAFT
- Disconnect engine mount on both sides from underneath → 103519 REMOVING AND INSTALLING ENGINE MOUNT .
- Disconnect front PDCC expansion hose.
- 4.1. Open the clamp -2- .
- 4.2. Disconnect expansion hose -1- .
- Disconnect servo line at the steering gear → 489419 REMOVING AND INSTALLING HOSE FOR POWER STEERING .
- Loosen design cover over cylinder bank 1 to expose the retaining eyebolts → 108319 REMOVING AND INSTALLING ENGINE COVER (DESIGN COVER) .
Only for 3.6 l & 4.8 l engines.
- Lift engine off engine carrier.
- 7.1. Carefully lift the engine initially using a workshop crane.
- 7.2. Make sure that the engine can be lifted up further without squashing or tilting components.
- 7.3. Secure loose components and auxiliary units.
- 7.4. Raise the engine.
- Move elevating platform out from under the engine.