| Lower wishbone to wheel carrier (taper bushing) |
M14 x 1.5 thread |
Tightening torque |
130 Nm (96 ftlb.) |
|
|
| Lower wishbone to spring strut |
M12 x 1.5 thread |
Tightening torque |
90 Nm (67 ftlb.) |
+120° |
|
| Steering spoiler (air guide) to lower wishbone with take-up hole |
M6 x 50 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Drive shaft to wheel hub (setting 1) |
Setting 1: Before installing the wheel carrier, M22 x 1.5 thread |
Tightening torque |
130 Nm (96 ftlb.) |
|
|
| Drive shaft to wheel hub (setting 2) |
Setting 2: With wheel carrier installed, M22 x 1.5 thread |
Tightening torque |
460 Nm (340 ftlb.) |
|
|
| Drive shaft to differential |
M8 x 53 thread |
Tightening torque |
22 Nm (16 ftlb.) |
+90° |
|
| Brake disc to wheel hub |
M6 screw |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Cable holder to wheel carrier |
M6 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake calliper to wheel carrier |
M14 x 1.5 thread (always replace screws and lock nuts after removal.) |
Tightening torque |
140 Nm (104 ftlb.) |
|
|
| Tie rod to tapered end of wheel carrier |
M12 x 1.5 thread |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Upper wishbone to tapered end of wheel carrier |
M12 x 1.5 thread |
Tightening torque |
85 Nm (63 ftlb.) |
|
|