Installing B-Pillar Cover

Pull window guide approximately half-way into the B-pillar cover.

Fig 1: Pulling In Window Guide
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push in B-pillar cover from the top and align it according to the marking.

Fig 2: Pushing B-Pillar Cover From Top
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in fastening screws -2- and tighten to the specified tightening torque Tightening torque 3.5 Nm +10° until secure.

Fig 3: Securing B-Pillar Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push window guide fully into the B-pillar cover.

Fig 4: Pulling In Window Guide
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Place roof molding in installation position.

Fig 5: Identifying Roof Molding Installation Position
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check that the rubber seal is fitted correctly in the B-pillar cover.
Secure roof molding with five blind rivets -1- .

Fig 6: Securing Roof Molding
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Affix detached areas of the window guide using double-sided adhesive tape (Part No. 000 043 206 59).

Fig 7: Detaching Window Guide
Courtesy of PORSCHE CARS NORTH AMERICA, INC.