Installing Rear-End Well

CAUTION: Danger of material damage if specified curing time of adhesive is not observed! In order to ensure that the bonded joint is sufficiently strong, the following conditions must be adhered to:

The vehicle must not be used until the curing time has elapsed.
Curing time: 2 hours
Temperature: at least 10 °c
Fixing time: approx. 1 hour

Information

Do not carry out any assembly work during the fixing time.

Information

When applying the adhesive, it is essential to ensure that the adhesive bead overlaps by approx. 30 mm at the beginning and at the end.

Prepare 2-component adhesive for processing. → WM 6X00IN PROCESSING OF PORSCHE 2-COMPONENT WINDOW ADHESIVE
Apply adhesive to the component.
1. 2.1. Using the bonding gun -a- , apply 2-component adhesive to the component along the preliminary coat or on the primer in the form of a triangular bead measuring -x = approx. 15 mm- .
  
  Fig 1: Applying Adhesive
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Information
- The adhesive has an open time of -15 min- , Which means that the bonding material must be applied and the component must be affixed within this period of time.
- To ensure that the substance is completely mixed, apply a 30-mm long bead of fresh adhesive to a piece of cardboard before processing.
  
  Fig 2: Identifying Adhesive Applying Time
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert the rear-end well into the body and press it into position.