Preliminary Work
WARNING:
Working on the vehicle electrical system
- Risk of burns
- Risk of short circuit or fire.
→ Disconnect the battery.
→ Prevent battery from reconnecting.
→ Cover the battery.
→ Remove ground terminal and cover the terminals.
→ Route electric lines without tensile strength.
→ Secure electric lines to existing lines/components.
- The battery ground lead must be disconnected before starting disassembly work. → 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
- Remove wiper arms. → REMOVING WIPER ARM
- Remove cowl panel cover in the plenum panel area. → REMOVING COWL PANEL COVER
- Remove plenum panel cover. → REMOVING PLENUM PANEL COVER
- Remove cross panel. → REMOVING CROSS PANEL
- Remove engine cover (design cover). → REMOVING ENGINE COVER (DESIGN COVER)
- Remove oil mist separator. → REMOVING OIL MIST SEPARATOR
- Loosen intake manifold on throttle housing. → REMOVING AIR BOX FOR THROTTLE HOUSING (Y-SHAPED PIPE AHEAD OF THROTTLE VALVE)
- Remove intake-air distributor. → REMOVING INTAKE-AIR DISTRIBUTOR
- Remove fuel distributor pipe. → REMOVING FUEL DISTRIBUTOR PIPE