Installing Wire Harness For Front-End

Information 

The number of plug connections can vary, depending on equipment.

1. Connection point for wire harness for front-end
2. Connector for pedestrian protection sensor
3. Connector for microswitch for front lid lock
4. Connector for control unit for garage door opener
5. Connector for ACC
6. Connector for outside temperature sensor
7. Connector for pedestrian protection sensor
Fig 1: Identifying Front-End Wire Harness Installation Position
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Position the wire harness and fit the nine clips as well as the clip at the wire harness junction.
   Fig 2: Fitting Clips

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   Fig 3: Fitting Wire Harness Junction Clip

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Plug in electric plug connection at the pedestrian protection sensors -2-  and -7-  until the connector clicks into place. → INSTALLING PEDESTRIAN PROTECTION
3. Plug in electric plug connection at the outside temperature sensor -6-  until it clicks into place. → INSTALLING OUTSIDE TEMPERATURE SENSOR
4. Plug in electric plug connection at the ACC system -5-  until the connector clicks into place.→ INSTALLING CONTROL UNIT FOR DISTANCE MEASURING SENSOR
5. Plug in electric plug connection at the microswitch for the front lid lock -3-  until the connector clicks into place. → INSTALLING MICROSWITCH FOR FRONT LID LOCK
6. Plug in electric plug connection at the control unit for the garage door opener -4-  until the connector clicks into place.→ INSTALLING CONTROL UNIT FOR GARAGE DOOR OPENER
7. Plug in electric plug connection at the connection point for the front-end wire harness -1-  until the connector clicks into place.
   Fig 4: Locating Plugging Connector Connection Point

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.