Removing Surround View Camera Control Unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

Information 

Always comply with the regulations for handling ESD-sensitive components!

• Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche. 
• The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed. 
• Never touch the electric pins and plug contacts. 

1. Release retaining lugs at the left and right -1-  and remove surround view camera control unit -2-  from the holder -3-  .
   Fig 1: Removing Surround View Camera Control Unit From Holder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Release clip -1-  (-2-  ), swivel it aside and disconnect electric plug connection from the surround view camera control unit -3-  .
   Fig 2: Disconnecting Electric Plug Connection

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.