LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera Edition >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> 91 - Radio, Stereo, Telephone, On-Board Computer -- PANAMERA (970) >> WM 911019 Removing And Installing Pcm Display And Operator Control Unit (Except PANAMERA S Executive, PANAMERA Executive, PANAMERA Turbo Executive, PANAMERA GTS) >> Removing PCM Display And Operator Control Unit

Removing PCM Display And Operator Control Unit

Fig 1: Identifying PCM Display And Control Unit
G09813740Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Switch off ignition and remove remote control.

    Information 

    Before removing/installing the PCM system, move the gear lever to 4th gear or the PDK selector lever to D.

    This protects the gear lever or selector lever from possible damage from the PCM housing.

  2. Unscrew the four fastening screws -1-  and pull out the PCM display and control unit.
    Fig 2: Unscrewing Fastening Screws
    G09813741Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Information 

    The number of plug connections can vary, depending on equipment.

  3. Release the securing clip -3-  on the central connector -2-  for the PCM by lifting up the locking lug -a-  .
  4. Release the central connector -2-  by opening -arrow A-  the securing clip -3-  and unplug it.
  5. Release and disconnect electric plug connections -4, 5, 6, 7, 8-  .
    6. Fig 3: Disconnecting Electric Plug Connections
    G09813742Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals