Installing PCM Display And Operator Control Unit

Plug in electric plug connections -4, 5, 6, 7, 8- until they engage securely.
Position and insert the central connector -2- . Close the securing clip -3- until it engages securely.
Information

Fig 1: Connecting Electric Plug Connections
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Before removing/installing the PCM system, move the gear lever to 4th gear or the PDK selector lever to D.

This protects the gear lever or selector lever from possible damage from the PCM housing.
Insert the PCM display and operator control unit into the mounting in the dashboard.
1. 3.1. Carefully insert the PCM display and operator control unit as far as it will go.
2. 3.2. Make sure that the lines are not pinched.
Secure the PCM display and control unit using the four fastening screws -1- . → Tightening torque: 7 Nm (5 ftlb.)

Fig 2: Tightening Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.