LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (13 - Engine - CRANKGEAR, Pistons 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 134819 Removing And Installing Crankshaft >> Preliminary Work

Preliminary Work

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine.

    > 100119 REMOVING AND INSTALLING ENGINE

  2. Remove transmission from engine.

    > Refer to 343527 Removing and mounting transmission in the appropriate service information. 

    or

    > WM 373427 REMOVING AND MOUNTING PORSCHE DOPPELKUPPLUNG (PDK) (EXCEPT PANAMERA S E-HYBRID, PANAMERA S HYBRID, PANAMERA EXECUTIVE, PANAMERA GTS, PANAMERA TURBO S,)

  3. Secure engine on assembly support.

    > 1001IN SECURING ENGINE ON ASSEMBLY SUPPORT (MOUNTING BRACKET)

  4. Drain engine oil. For details, see

    > 170117 DRAINING AND FILLING ENGINE OIL (CHANGING ENGINE OIL)

  5. Disassemble the engine. Cylinder heads are removed, but must remain intact. The starter, knock sensors, thermostat housing and coolant guide remain fitted on the crankcase. For details, see

    > 1001Z1 DISASSEMBLING ENGINE