Removing Oil Mist Separator
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Engine ventilation/oil mist separator
- Molded seal
- Molded seal
- Screw elements, M6
- Disconnect line connections to the connection piece on the oil mist separator. To do this, press on the grooved surfaces and pull off the connection. -1-
- Loosen screws -2-
. Screws are permanently connected. If screws are damaged, press the screws out of the oil mist separator and replace them.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove oil mist separator from the valve cover. At the same time, check the seals and replace them if damaged.