LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 10 - Engine - Crankcase, Suspension -- PANAMERA (970) >> WM 103719 Removing And Installing Torque Support (PANAMERA, PANAMERA S, PANAMERA 4, PANAMERA 4S, PANAMERA Turbo, PANAMERA GTS, PANAMERA Turbo S, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Removing Torque Support

Removing Torque Support

  1. Removing upper torque support => 
    1. 1.1. Remove the two screws and nuts on the body and valve cover → Installation position of upper torque support  .
      1. Aluminum screw, M10
      2. M10 nut; counter when using tools.
      3. Bracket on valve cover
      4. Bracket on body
      5. Torque support; part identification on the back, must be installed in opposite direction to direction of travel.
      Fig 1: Identifying Installation Position Of Upper Torque Support
      G09804267Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    2. 1.2. Remove torque support.
  1. Removing lower torque support => 
    1. 1.1. Remove the two screws on the engine bracket and on the supporting frame → Installation position of lower torque support  .
      1. Steel screw, M10 x 95
      2. Steel screw, M10 x 65
      3. Torque support
      Fig 2: Identifying Installation Position Of Lower Torque Support
      G09804268Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    2. 1.2. Remove torque support.
scientia non olet · About LEMON Manuals