Installing Brake Pedal

Information 

Hybrid only: 

• The magnetic holder at the brake pedal must not be loosened or adjusted. 
• If the magnetic holder at the brake pedal was adjusted, the brake pedal must be replaced. 

Information 

The cover on the pedal shaft is coded. This means that the pedal shaft can only be fitted correctly in one specific position.

It is important to check that the lugs on the cover are engaged in the cut-outs in the base of the pedal.

This is the only way to ensure that the pedal shaft is installed at the correct position and will not turn.

The pedal shaft must not be greased during installation! 

1. The brake pedal is installed in reverse order to removal.