Removing B-Pillar

Information 

Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

Information 

Mark cuts A, B, D and E  in accordance with the new part. Make sure to leave an overlap of approx. 3 cm with respect to the body.

1. Mark and make cuts.

   Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
   Dimension C		Distance	20 mm

   Fig 1: B-Pillar Component Location

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

2. Drill out spotwelds using spotweld drill Nr.129  .
   Fig 2: Removing B-Pillar

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Heat up connection area using a hot-air gun.
   Fig 3: Identifying Connection Area

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Remove B-pillar.