Installing Rear Spoiler Trim

Heat and remove remaining adhesive tape using the hot-air blower, Leister-Electron/V.A.G. 1416 WE 1119 .

Fig 1: Preparing Bonding Surfaces
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clean bonding surfaces with silicone remover.
Pull off protective film on one side of the new strips of adhesive tape and stick adhesive tape onto the markings on the lower part of rear spoiler.
Information

Make sure that the rear spoiler trim does not touch the upper strips of adhesive tape.
Pull off protective film on strips of adhesive tape. Fit rear spoiler trim -arrow- and align it at the front cut-out.

Fig 2: Fitting Rear Spoiler Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press on rear spoiler trim at the front first -arrow A- . Then swivel the rear spoiler trim down and press it on at the top -arrow B- .

Fig 3: Installing Rear Spoiler Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.