Installing Flywheel
- Block flywheel. To do this, attach toothed segment 9538/1
to a screw hole at the bottom of the oil guide housing so that at least one tooth engages with the ring gear. → Toothed segment
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Fit new screws crosswise.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 2
- Screw securing flywheel to crankshaft → Initial tightening: 60 Nm (44 ftlb.)
and → Final tightening: 90°
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- PDKit flywheel
- Screw securing flywheel to crankshaft → Initial tightening: 60 Nm (44 ftlb.)
and → Final tightening: 90°