Removing (Outer) Rear Wheel Housing

Remove rear side panel.→ 535555 replacing rear side panel
Mark and make the required cut. → Distance: 30 mm

Fig 1: Rear Wheel Housing Component Location
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Bend up sheetmetal bracket.
1. 3.1. Drill out spotweld using Spotweld drill nr.129 .
2. 3.2. Heat connection area using a hot-air gun.
3. 3.3. Bend up sheetmetal bracket -arrow- .
  
  Fig 2: Removing (Outer) Rear Wheel Housing
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Drill out spotwelds using Spotweld drill nr.129 .

Fig 3: Drilling Out Spotwelds
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Heat connection areas using a hot-air gun.

Fig 4: Removing (Outer) Rear Wheel Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove (outer) rear wheel housing.