Installing Wing

Information 

• Set gap dimensions on lid and accessories in accordance with the gap specifications  .
• Given a clearance in the opening that is too great or too small, the accessories must be centered with respect to the body  .
• Ensure that the gaps do not run in a wedge-shaped fashion or do not narrow at local points  .
• The given values are guidelines, which should be observed as far as possible  .
• The guidelines apply to repair and assembly work  .
• Use star gauges to check the gap dimensions. Star gauges for body gap dimensions NR.127-1 

1. The wing is installed in reverse order to removal.
   1. 1.1. Set gap dimensions by moving the wing. → Technical Values 
   2. 1.2. Replace the fastening screw on the lock carrier with a new screw.
2. Tighten fastening screws securing wing to bodyshell to the specified tightening torque Tightening torque 9.7 Nm +/-1 Nm (+/-0.5 ftlb.)  until secure.
3. Tighten fastening screws securing wing to lock carrier to the specified tightening torque Tightening torque 5.5 Nm (4 ftlb.) +/-0.5 Nm (+/-0.5 ftlb.)  until secure.