Checking Thickness Of Brake Pads

→ Only use the type-specific brake pads listed in the Porsche Parts Catalogue.

→ Replace the brake pads when the brake pad wear indicator light comes on, but no later than when there is a residual pad thickness of 2 mm on each axle.

→ Replace the brake discs on each axle upon reaching the wear limits.

Information 

• If brake pad wear is indicated by the warning light, the warning contact (sender including wire and plug connection) must also be replaced. 
• Replacement of the warning contact can be avoided by replacing the brake pads no later than when the pad thickness is 2.5 mm -arrow-  .
  Fig 1: Identifying Thickness Of Brake Pads

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
• Warning contacts must be replaced if the core of the line is worn. 
• However, if only the plastic part of the warning contact is worn, there is no need to replace it. 

Raise the vehicle → 4X00IN LIFTING THE VEHICLE .

Remove wheel. Use assembly aids (assembly pins) -1-  .

→ 440519 REMOVING AND INSTALLING WHEEL .

Fig 2: Identifying Assembly Aids (Threaded Bolts For Fitting Wheel)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Visually inspect the brake pads for wear.