LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Panamera 4S >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> 70 - Linings, Insulation -- PANAMERA (970) >> WM 706719 Removing And Installing Lower Part Of B-Pillar Trim Panel (Except PANAMERA Executive, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Installing Lower Part Of B-Pillar Trim Panel

Installing Lower Part Of B-Pillar Trim Panel

Information 

Check that all fixing clips are positioned fully and correctly.

Check that the fixing clips are not bent or broken.

Replace damaged or missing clips with new ones.

  1. Lift up rear part of door sill trim.
  2. Clip in lower part of B-pillar trim panel.
    Fig 1: Fitting Lower Part Of Trim Panel
    G09812337Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Swivel B-pillar trim panel into place and clip it in.
    Fig 2: Installing B-Pillar Trim Panel
    G09812338Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Tighten fastening screw -1-  to specified tightening torque Tightening torque 5.5 Nm (4 ftlb.)  until secure.
    Fig 3: Securing Ventilation Duct
    G09812339Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Position armrest extension -2-  and align according to the contour of the armrest on the door panel.
    Fig 4: Positioning Armrest Extension
    G09812340Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Secure armrest extension.
    1. 6.1. Tighten fastening screw -3-  to specified tightening torque Tightening torque 5.5 Nm (4 ftlb.) until secure.
    2. 6.2. Fit cap -4-  .
    Fig 5: Securing Armrest Extension
    G09812341Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Clip in rear part of door sill trim.
    Fig 6: Clipping In Door Sill Trim
    G09812342Courtesy of PORSCHE CARS NORTH AMERICA, INC.