Adjusting Height Of Rear Lid

Information 

• Set gap dimensions on lid and accessories in accordance with the gap specifications. 
• Given a clearance in the opening that is too great or too small, the accessories must be centered with respect to the body. 
• Ensure that the gaps do not run in a wedge-shaped fashion or do not narrow at local points. 
• The given values are guidelines, which should be observed as far as possible. 
• The guidelines apply to repair and assembly work. 
• Use star gauges to check the gap dimensions. Star gauges for body gap dimensions NR.127-1 
  Fig 1: Identifying Rear Lid Installation Position

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Check adjustment.
   1. 1.1. Check gap dimensions on the body → 559015 ADJUSTING REAR LID 
2. Adjust the height of the rear lid with respect to the body.
   1. 2.1. Loosen fastening screws -1-  on the hinge at the rear lid on both sides so that the lid can still be moved.
      Fig 2: Loosening Fastening Screws On Hinge At Rear Lid

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   2. 2.2. Adjust the height of the lid by moving the lid and ensure that the gap between the lid and roof is parallel → 559015 ADJUSTING REAR LID 
      Fig 3: Adjusting Lid

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   3. 2.3. Tighten fastening screws -1- → Tightening torque: 23 Nm (17 ftlb.)  until secure.
      Fig 4: Securing Mounting Screws For Hinge On Lid

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Check gaps and make adjustments if necessary.