Replacing Combination Sensor

Fig 1: Identifying Installation Position Of Combination Sensor

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew and remove fastening screws -1- and remove combination sensor.

Fig 2: Removing Combination Sensor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Release electric connector -1- and disconnect it -2- .

Fig 3: Disconnecting Electric Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position new combination sensor and center it.
Tighten fastening screws -1- .
→ Tightening torque: 10 Nm (7.5 ftlb.)+/-1 Nm (+/-0.5 ftlb.)

Fig 4: Centering Combination Sensor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect electric connector until it engages securely. → Connecting electric connector

Fig 5: Connecting Electric Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.