Painting And Dyeing

→ Ventilate the work area well.

→ Never ingest or inhale.

→ Read specific information on the Hazard Sheet.

→ Do not smoke, eat or drink in the work area.

1. From the color samples choose the color that most closely matches the original.
2. Shake paint container thoroughly before mixing.
3. Mix paint on the paint scales interior repair scales, small (0.01g scale) WE 1357  in accordance with the formulary.
4. Mix paints thoroughly and compare the color obtained with the original. To do this, dab or spray some of the paint onto the original part.

   Critically examine the color match of the paint when dry  . It is often necessary to adapt the color mixture and sometimes this may take several attempts.

5. If necessary, match the sheen and color intensity using the additive "Opacante A". The amount of this additive that can be added to the paint must not exceed 25%.
6. Check adhesion of paint by gently scratching the dry paint.
7. If the color is correct, apply paint to the damaged area using paint-spraying gun - Sata-Minijet WE 1146  or an airbrush gun.

   For small areas of damage, the paint can also be applied using a clean, lint-free cloth. In this case, apply the paint in several layers using a circular motion.

   Fig 1: Painting Repaired Area

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
8. Leave paint to dry at a temperature of no less than 16°C for approx. 90 min. It may take less time to dry at warmer temperatures.

   The drying time should be increased if the paint was applied in several layers.

9. Match the lustre, if necessary:
   • "Matt fix scan" provides a matt finish.
   • "Gloss fix scan" provides a gloss finish.
   • A satin finish is achieved by mixing the two gloss regulators.
   1. 9.1. Shake gloss regulators thoroughly and filter through a paper filter.
   2. 9.2. Mix "Matt fix scan" and "Gloss fix scan" thoroughly in the desired ratio.
   3. 9.3. Test gloss regulator in a concealed area.
   4. 9.4. Check the lustre when dry and adapt if necessary.
   5. 9.5. Apply the gloss regulator using paint-spraying gun - Sata-Minijet WE 1146  or an airbrush gun.

      For small areas of damage, the gloss regulator can also be applied using a clean, lint-free cloth. Apply it using a circular motion.

10. Leave the paint to dry overnight before applying any load.

Observe the information and instructions provided by the tool manufacturer as well.

The various repair methods can only be learned through intensive training.